Strom & Sanitäreinrichtung - Seite 225

Adapter union- gunmetal nozzle, brass threaded connection- soldered connection, Rp-thread- conical sealing.

T-piece - copper - solder connection.

T-piece - copper - solder connection.

Flashlight XP9R 1000 lumen, rechargeable, slide Focus, Beam Lock, IP54

Air screw with thumb screw, self-sealing. Fits 1/2" RG. Material: Nickel-plated brass.

Pump stop wire for easy installation of circulation pump in KL08RF.

Salus EP Electronic A-class circulation pump for heating systems and other non-corrosive liquids, ensuring high comfort and low energy consumption.The EP circulation pump is mainly used for water circulation in home heating, and is best suited for the following system:• Stable heating system with variable flow• Heating system with variable pipeline temperature• Industrial circulation system• House and apartment heating systemsThe EP circulation pump can adjust the electric pump's performance automatically and continuously to meet the actual needs of the systemThe EP circulation pump is equipped with a control panel on the front, which is convenient for users. Easy installation and startupEP circulation pump has automatic adaptation mode AUTO (factory setting). In most cases, you can start the pump without making any adjustments and let it automatically adjust to meet the actual needs of the system. High comfortThe operating noise of the pump is low. Low energy consumptionCompared to the conventional circulation pump, its energy consumption is very low. The minimum energy consumption for the EP circulation pump can reach 5 W.EP circulation pump does not need external motor protection. Check whether the voltage and frequency of the power supply correspond to the parameters indicated on the pump nameplate. Use the pump's corresponding connector to connect the power supply (EPPLUG).

SALUS GVU is a complete floor heating shunt solution for underfloor heating with underfloor heating manifold, shunt and circulation pump built together in one unit.Our circulation pump is a 6m pump with capacity up to 16 zones. The underfloor heating manifold is a high flow manifold with manual balancing of each circuit. Each valve has a built-in manual flow control which is very easy to adjust. Instructions on how to balance the circuit can be found in the distributor box.The SALUS GVM floor heating manifold has a manual vent on each pipe and a drain valve with 1/2 ”thread for hose. The Inlet thermostat has a temperature setting of 20 to 55 degrees Celsius. Manifold pipe connection is 1 ", and connection to water for the heat supply is 3/4" socket, and threads to the actuator are 30 x 1.5 mm.

Insulated bace module with stainless floor heating manifold incl. Drain, air screw and 20mm connector. Rødgod distributors for domestic water incl. 15mm connector. The base modules have universal adaptation, so they fit the market's well-known brands with easy adjustment. Unique for SALUS base module. Connection at the top from right to left KV Cold water-VV Hot water-VF Heating forward-VR Heating return.Insulated distributors and pipes according to DS452The underfloor heating control is mounted directly on the bottom module DIN.

Insulated bace module with stainless floor heating manifold incl. Drain, air screw and 20mm connector. Rødgod distributors for domestic water incl. 15mm connector. The base modules have universal adaptation, so they fit the market's well-known brands with easy adjustment. Unique for SALUS base module. Connection at the top from right to left KV Cold water-VV Hot water-VF Heating forward-VR Heating return.Insulated distributors and pipes according to DS452The underfloor heating control is mounted directly on the bottom module DIN.

Li­Ion PLUS technology. Highly resistant Li-­Ion 12V battery with 2.5 Ah capacity for long service life. Powerful and light. Total discharge and overload protection with single cell monitoring. Temperature monitoring during the charging process. Operating temperature range –10 to +60 °C. No memory effect for maximum battery power.

Power-transmitting pipe holder. For assembly and demolition. Unique pipe holder that 5 times the power transfer – allows easy, fast, perpendicular sawing on site, without the use of a vise. Ideal handling, easy and quick operation, just one handle for clamping and sawing. No freely swinging chain and cumbersome operation, as when using a chain vise. No clamping option, as the swing angle is limited. 400% more sawing power available for a power-saving, super-fast sawing during assembly and demolition, e.g. a 4" steel pipe in just 8 seconds. With the pipe holder installed, for optimal sawing, it is recommended to use a straight hand grip.

HiluX D1 Gen3 – Full Spectrum LED Recessed spot

For professionals who require technically advanced and reliable lighting solutions, the HiluX D1 Gen3 built-in spotlight is the obvious choice. This Full Spectrum LED spot is specially designed to both improve aesthetics and optimize energy efficiency in any room.

Used for draining away condensed water when the interior is used for cooling. The condensation hose is provided with a sleeve for every half meter with 2 different connection diameters (14/19 mm).

Vibration-damping rubber feet for heat pumps. Str. 600 X 95 X 130 mm (LxHxW). Set of 2 pcs. With mounting rail and fastening bolts.

Vibration-damping rubber feet for heat pumps. Str. 1000 X 95 X 180 mm (LxHxW). Set of 2 pcs. With mounting rail and fastening bolts.

Vibration-damping riser for rubber feet. Fits rubber feet from Andersen Electric in size 1000 X 95 X 180 mm. Str. 1000 X 130 X 190 mm (LxHxW). Set of 2 pcs. Simple installation.

Lia is a stylish LED microdownlight, which is approved for direct installation in insulation and combustible material. Ideal for mounting in window openings, cupboards and as decorative lighting. Prepared for installation in 16 mm flex pipe. Delivered incl. 3 meter cable.

Luna is an innovative, flicker-free LED downlight, which is approved for direct installation in insulation and combustible material. The front is made of stainless acid-resistant steel AISI 316. Due to assembly using screws and/or springs, a perfect result is ensured - every time! The installation height of only 33 mm makes it possible to install Luna in most places. The replaceable LED light source makes the installation flexible and future-proof - for example if a different color temperature is desired. It is possible to mount with cable or 16 mm flex pipe.

Martina is a simple and stylish wall lamp that provides a pleasant, glare-free light. The light opening in the side creates an elegant "corona effect" on the wall/house wall. Martina can be used both indoors and outdoors in homes, businesses, housing associations, hotels, etc. The fitting is made of die-cast aluminum and is supplied in the colors anthracite gray and black, with and without half shielding, and is prepared for further looping with 3G1.5 mm2. Delivered incl. spacers that can be used for visible installation.

Luna Low profile 2.0 is the second generation of the popular and reliable Luna Low profile. Version 2.0 has been refined with better efficiency, a lumen package of up to 490 lm and an output of only 5.9W. LED driver and connection box are divided and the smart connection box with a height of only 20 mm is prepared for installation with cable or flex pipe. The new clamps make connection a breeze without sore fingers. Luna Low profile 2.0 naturally still has a replaceable light source, so it enables an easy change between different color temperatures if the needs of the home's future owners should change, while the light quality is top notch with a Ra value >90. Luna Low profile 2.0 is IP44 and suitable for both indoor and outdoor mounting as well as directly in insulation.

Primofit compression angle for 1'' for steel pipes

Primofit FKM Gasket 1.1/2'' for high temperatures. Max. 150°C

Primofit FKM Gasket 3'' for high temperatures. Max. 150°C

With FESH SMART camera "solar panel" you always have power on your outdoor camera - Suitable for: art. no. 204030 or 204035 – You do not need to take the camera down to charge it – Make your camera independent of the mains – Ideal for places where 230V is not available – Flexible, can be moved without requiring changes in the installation.

Main features:

• Compact size
• Connection with USB-C
• Easy to install (bracket included)
• Can be placed up to 3 meters from the camera
• Ideal where 230V is not available, e.g. boats, camping, allotment houses, construction sites