Kocher und Rauchabzug

• Type RM 8 (8 l/min).• With filter, non-return valve, 6 bar manometer, 1/2 hose fitting and worm drive hose clip with 3/4 locking nut.• Suitable for primary pressure up to 10 bar.• Regulates between 0.4 - 3.0 bar (1.5 bar factory set).• Maximum working temperature: 70 °C.• Maximum glycol content: 50%.

• Maximum working pressure: 6.0 bar.• Vessels in accordance with EN13831.• Suitable for systems with a maximum flow temperature of 120 °C.• Maximum temperature diaphragm: 70 °C.• Suitable for addition of glycol-based anti-freeze up to 50%.• In accordance with Pressure Equipment Directive 2014/68/EU.

• Maximum working pressure: 3.0 bar.• Vessels in accordance with EN13831.• Suitable for systems with a maximum flow temperature of 120 °C.• Maximum temperature diaphragm: 70 °C.• Suitable for addition of glycol-based anti-freeze up to 50%.• In accordance with Pressure Equipment Directive 2014/68/EU.

• Maximum working pressure: 3.0 bar.• Vessels in accordance with EN13831.• Suitable for systems with a maximum flow temperature of 120 °C.• Maximum temperature diaphragm: 70 °C.• Suitable for addition of glycol-based anti-freeze up to 50%.• In accordance with Pressure Equipment Directive 2014/68/EU.

• Maximum working pressure: 3.0 bar.• Vessels in accordance with EN13831.• Suitable for systems with a maximum flow temperature of 120 °C.• Maximum temperature diaphragm: 70 °C.• Suitable for addition of glycol-based anti-freeze up to 50%.• In accordance with Pressure Equipment Directive 2014/68/EU.

Chimney support is used where the free-standing height of the chimney, above the roof, exceeds 2.75 meters. The chimney support consists of brackets and two telescopic rods (1500 mm).

The 2-part ceiling collar is used for covering the chimney in ceiling with slope from 11° to 38°.

The 2-part ceiling collar is used for covering the chimney in ceiling with slope from 11° to 38°.

Used for all flashings. The included silicone ensures a weather-resistant installation.

The flashing consists of aluminum or Metalbestos flex, to which a conical aluminum part is attached. The aluminum version is intended for roofing felt or slate. Metalbestos-flex design is intended for roofing of corrugated boards or tiles.(Remember to order collar for flashing).

The flashing consists of aluminum or Metalbestos flex, to which a conical aluminum part is attached. The aluminum version is intended for roofing felt or slate. Metalbestos-flex design is intended for roofing of corrugated boards or tiles.(Remember to order collar for flashing).

Used where the chimney passes through floors. Secures the chimney's stability and bearing.

Appliance Connector Outer 148mm

For pellet boilerInner diameter: 129 mm

Set of 2 anglesMaterial: PPS/ALUColour: white

Material: PPS/ALUColour: white