Komponenten für Schaltkästen und Schränke - Seite 46

Zubehör für den Schalter

MS116-2.5 manual motor starter is a compact 45 mm width devices with a rated operational current of Ie = 2.5 A. This device is used to manually switch on and off motors and to protect them reliably and without the need for a fuse from short-circuits, overload and phase failures. The manual motor starter offers a rated service short-circuit breaking capacity Ics = 50 kA at 400 VAC and the trip class 10A. Further features are the build-in disconnect function, temperature compensation, trip-free mechanism and a rotary handle with a clear switch position indication. The manual motor starter is suitable for three- and single-phase applications. Auxiliary contacts, signalling contacts, undervoltage releases, shunt trips, 3-phase bus bars, power in-feed blocks and locking devices for protection against unauthorized changes are available as accessory.

SA 1 Verriegelungsvorrichtung für MCB, ohne Vorhängeschloss

DEVIreg TM 330 is a series of simple electronic thermostats for installation in cabinets withDIN rail bracket. To measure and control the desired temperature, either one must be usedwiring sensor (in the kit) or an external or space sensor. The thermostat must be installedafter a multi-pole switch. It has an LED indicator that shows standby periods (green light) andheating periods (red light).DEVIreg TM 330 has a relay with two contact pairs - NO (normally open) and NC (normally closed) andis intended to be used for heating and cooling systems. In addition, the NO and NC contact pairsnot supplied by a voltage source inside the thermostats and can be used forcontrol systems with any voltage up to 250 V.The series is designed with thermostats in three temperature ranges.DEVIreg TM 330 (-10 - +10 ° C) is primarily used to control a lower temperature range such asantifreeze. This thermostat has a knob for adjusting the temperature setting with a scalefrom -10 to +10 ° C. Special outdoor wire with white wire, 2,5m, is included in a set.

Frontbedienbarer Schalter-Lasttrennschalter. Typen OT 16...125 enthalten geschützte Klemmen, IP 20.

Frontbedienbarer Schalter-Lasttrennschalter. Typen OT 16...125 enthalten geschützte Klemmen, IP 20.

Frontbedienbarer Drehschalter für Standardöffnung von 45 mm. In der AUS-Position mit einem Vorhängeschloss (Bügeldurchmesser 5 mm) abschließbar

Wählschaltergriff. Anzeige I-O und AN-AUS. Keine separate Welle erforderlich. Mit max. 3 Vorhängeschlössern abschließbar, IP 65, Lochabstand 36/48 mm, NEMA 1, 3R, 12, schwarz, OT16...125FT

Wählschaltergriff. Anzeige I-O und AN-AUS. Keine separate Welle erforderlich. Mit max. 3 Vorhängeschlössern abschließbar, IP 65, Lochabstand 36/48 mm, NEMA 1, 3R, 12, rot-gelb, OT16...125FT

Terminalabdeckung für OT16...40F3, -FT3, 3-polige Abdeckung, transparent.

AF09 contactors are used for controlling power circuits up to 690 V AC and 220 V DC. They are mainly used for controlling 3-phase motors, non-inductive or slightly inductive loads. AF... contactors include an electronic coil interface accepting a wide control voltage Uc min. ... Uc max. Only four coils cover control voltages between 24...500 V 50/60 Hz or 20...500 V DC. AF contactors can manage large control voltage variations. One coil can be used for different control voltages used worldwide without any coil change. AF contactors have built-in surge protection and do not require additional surge suppressors. The AF... series 1-stack 3-pole contactors are of the block type design. - Main poles and auxiliary contact blocks: 3 main poles, 1 built-in auxiliary contact, front and side-mounted add-on auxiliary contact blocks (mechanically-linked auxiliary contacts compliant with Annex L of IEC 60947-5-1. N.C. mirror contacts compliant with Annex F of IEC 60947-4-1) - Control circuit: AC or DC operated - Accessories: a wide range of accessories is available.

Die ESB25..N Installationskontaktoren werden verwendet, um ein- und dreiphasige Lasten bis zu 25 A zu steuern und können mit AC- oder DC-Spannungen betrieben werden. Diese Kontaktoren sind für den Einsatz in Haushaltsanwendungen sowie in industriellen Umgebungen konzipiert. Die folgenden Vorteile werden geboten: Geräuschfreier Betrieb, geringer Stromverbrauch und integrierter Überspannungsschutz. Verschiedene Kontaktkombinationen und Zubehörteile sind erhältlich.

Stromzähler, 3-Phasen, aktive Energie Kl. 1 & B, zugelassen nach: IEC 62052-11, IEC 62053-21, EN 50470-1, EN 50470-3

TeSys D - Hilfskontaktblock - 2 Öffner + 2 Schließer - Schraubklemmen

TeSys D - Hilfskontaktblock - 3 NO + 1 NC - Schraubklemmen

Hauptmastmodul 20 A - für V01

TeSys GV2 - Leitungsschutzschalter - thermomagnetisch - 1...1,6 A - Schraubklemmen

TeSys K Schütz - 3P(3 NO) - AC-3 - <= 440 V 6 A - Spule mit 230 V AC

shaft extension - Mini-VARIO and VARIO - for V3 / V4 / V5 / V6

TeSys K Schütz - 3P(3 Ö) - AC-3 - <= 440 V 9 A - Spule mit 24 V Gleichstrom

TeSys K Schütz - 3P(3 NO) - AC-3 - <= 440 V 9 A - Spule mit 24 V AC

early-break/late-make auxiliary contact block - VARIO - 1 NO + 1 NC

Wellenverlängerung - Mini-VARIO und VARIO - für V02...V2 / VN12 / VN20

TeSys GV2 & GV3 - Hilfskontakt - 1 Öffner/Schließer

TeSys GV2-Sicherungsautomat-thermisch-magnetisch - 0,63...1 A - Schraubklemmen