Unidrain Entwässerungsprodukte - Seite 4

Armatur Unidrain 1004 300 mm ohne Flansch.

Armatur Unidrain 1003 1000 mm Ecke rechts.

Armatur Unidrain 1003 900 mm Ecke rechts.

Rahmen Unidrain 1500 900X8 mm.

Rahmen-Unidrain 1500 900X12 T/1001.

Outlet-Haus Unidrain Ø50 horizontal mit Wassersperre.

Panel Unidrain Highline CUSTOM 1000

Inkl. abnehmbarer Wasserfalle (kann getrennt und gereinigt werden). 180° umkehrbar, wenn ein rückwärtiger Auslass erforderlich ist.

For testing of the wetroom solution for leaks before laying tiles. Placed in the drain unit. Fill the shower niche with 20-mm water and allow to stand for 24 hours to test the seal.

Unidrain-Ablaufeinheit Ø50 mm inkl. Wassersperre

Exclusive frame design with upper section of solid 4-mm stainless steel.

Insert ensures a snug fit inside the drain unit.

The frame enhances the exclusive design of the floor drain.

Frame available in 10, 12, 15 and 25 mm heights (depending on the thickness of the floor tile).

NB! Frame height (H) = tile thickness + approximately 2 mm for tile mortar and membrane.

Großer Unidrain Quadrat 1604 mit einer Länge von 1000 mm.

The riser piece is inserted between the outlet housing and the drain channel, and can thus raise the fitting or lower the outlet housing by 35.7 mm.

With side drain on the left.

Can be freely positioned against the back wall, independent of any side walls. Only for use with ClassicLine.

Available in 8, 10 and 12 mm heights (depending on the thickness of the floor tile). The rubber insert ensures a snug fit inside the unit. A countersunk bearing ensures that the grating fits perfectly into the frame. The frame is non-optional and has two functions: To support the grating and give a perfectly flush finish with the tiled floor.

NB! Frame height (H) = tile thickness + approximately 2 mm for tile mortar and membrane.

Unidrain Highline CUSTOM 700 Panel

Rist Unidrain Spalte 1602 ist 700 mm.

Outlet-Haus Unidrain vertikal EX-Falle Ø50.

Outlet-Einheit | Leitung | Ø 75 mm vertikal, inkl. Wassersperre

Eckmontage Unidrain 2011.

Available in 8, 10 and 12 mm heights (depending on the thickness of the floor tile). The rubber insert ensures a snug fit inside the unit. A countersunk bearing ensures that the grating fits perfectly into the frame. The frame is non-optional and has two functions: To support the grating and give a perfectly flush finish with the tiled floor.

NB! Frame height (H) = tile thickness + approximately 2 mm for tile mortar and membrane.

Rist Unidrain-Säule mit Abmessungen von 1602 x 800 mm.

The grating is placed on a countersunk bearing in the frame, to hold it securely.

Only for use with ClassicLine frame.

Outlet-Haus Unidrain vertikal EX-Falle Ø75.

Highline Rahmen - Gebürsteter Stahl 800/10 mm