Triax Antennenkabel

- 1 RF IN / 2 RF OUT
- LED indicates operation
- Recommended for eg TRIAX UFO antenna
- Auto-terminating F-connectors

IFP224 has two outputs. If the IFP224 is installed in a location that requires only one output, it is not necessary to connect a 75 ohm resistor (which the installer often forgets!) To the other unused output, thanks to the auto-terminating F-connector. This connector is 75 ohms terminated as standard, as long as no F-male connector is connected to it.

Kabelsatz-Kit Cc-sp 01

Triax F-connector to Coax female angled 2pack

TD 241 E is a selective coaxial Multimedia wall outlet to be used in interactive CATV-networks, in well isolated branch lines from the CATV multi-tap.

- High isolation between TV and the DATA port (F-female) avoids interference produced from the modem operation
- Unsymmetrical and selective coupling of upstream and downstream to the DATA port enables lowest insertion loss and zero intermodulation for the upstream signal
- Shielding comply to Class A+ (Class A + 10dB) according to EN 60728-2 (5.5)

Nachfüllpatrone, Grün, Geltinte, 0.4 mm, für Schneider Gelion 1

TRIAX Adapter Keystone F

Antennenkabel, IEC-Anschluss männlich zu IEC-Anschluss weiblich, 5 m, doppelt abgeschirmtes Koaxialkabel, weiß

Antennenanschluss für TV / Radio / SAT und zusätzlicher F-Stecker. Kann für das Satellitensignal, z.B. Twinbox, oder zum Zurücksenden des Signals verwendet werden. Wird komplett mit Rahmen und Abdeckung geliefert. Endsteckdose.

Antennen-Splitter, F-Stecker (W) bis F-Stecker (W)

F-56-CX3 7.0 QM (Quick-mount)F-compression connector quick mount for very easy mounting on the coax cables. Waterproof. With o-ring.Class A+Fast mounting, no braid fold backPerfect for hard cables with PE-jacket

TRIAX' FUGA outlets have a high shielding factor and are very easy to mount. The design, where backplate and terminals are die cast in one piece sets new standards for mechanical stability and high shielding.

TRIAX' FUGA outlets have a high shielding factor and are very easy to mount. The design, where backplate and terminals are die cast in one piece sets new standards for mechanical stability and high shielding.